Bend Table Parameters
The following bend table parameters are displayed in the user interface of the application:
- Radius — the bend internal radius, in mm or inches (default is mm). The radius value can also be 0.
- Thickness — it can be in mm or inches (default is mm). The thickness value cannot be 0.
- Angle — the angle is measured in degrees. The range is 0° to 360°. There are two different ways to measure the bend angle:
- Inside (1) — the angle is measured from inside
- Outside (2) — the angle is measured from outside (default).
As shown in the following illustration:
Refer to the Bend Table Format document to learn about other bend table parameters that are not visible in the user interface but are part of the Bend Table.
Related Topics
e-Learning on Sheet Metal