Insert
MoldDesignMold BasePEDROTTI
The PEDROTTI Mold Base command enables you to create the mold base according to the Pedrotti catalog. The Pedrotti wizard is customized with the terminologies and values related to the Pedrotti catalog. The pictorial representation of the different parts of the assembly enables you to make the selection faster and easier.
On starting the command, the Mold Base-Pedrotti wizard is displayed. The wizard contains four tabs named as Basics, Plates, Guide Elements, and Fasteners as shown in image below.
| Note If you have not installed the catalog, the software prompts you to install it on starting the command. |
In the Basics tab, 16 Mold base assemblies are displayed pictorially. Select the required assembly by clicking on the image or by choosing it from the Assembly Type drop-down list. Also you can select the Mold base series from the Series (W*L) drop-down list. When the series is selected, the values corresponding to the series are automatically updated in the other tabs for selection.