Insert
MoldDesignMold BaseFUTABA
The FUTABA Mold Base command enables you to create the mold base according to the Futaba catalog. The Futaba wizard is customized with the terminologies and values related to the Futaba catalog. The pictorial representation of the different parts of the assembly enables you to make the selection faster and easier.
On starting the command, the Mold Base-Futaba wizard is displayed. The wizard contains four tabs named as Basics, Plates, Guide elements, and Fasteners as shown in the image below.
| Note If you have not installed the catalog, the software prompts you to install it on starting the command. |
In the Basics tab, 8 Mold base assemblies are displayed pictorially. Select the required assembly by clicking on the assembly image or select it from the Type drop-down list. Also select the series from the Series drop-down list. When the series is selected, the values corresponding to the series are automatically updated in the other tabs for selection. The Mold base assembly base can be fixed with bolt or clamp that can be specified by the Board Specification drop-down list.