Insert
Curve Conics Ellipse
The Ellipse command enables you to create an ellipse in one of the methods available in the Type drop-down list:
| Center, major and minor axis | Enables you to create an ellipse or elliptical arc defined by its center point and its major and minor axes. |
| 2 vertices and 1 point | Enables you to create an ellipse defined by two vertices and passing through a third point. |
The Associative Mode check box enables you to create curves which retain a link to the surfaces/curves they derive from.
 |
When the check box is selected, the resulting curves will be associative. The new curve will retain a link to the entities it derives from. A specific node displaying both the original entities and the resulting associative curve will be added to the Model Structure. |
|
When the check box is cleared, the resulting curves will not be associative. |
The Restore Selection button ( 
) — enabling you to use the last selections and settings again without having to repeat them all — can be available in the selection list. See "
Restore Selection modality for selections and settings" for details.
In case the supplied geometric data are not consistent and the curve cannot be created, the Show Warnings button ( 
) shows up on top of the selection list. If you click it, an appropriate warning explaining the issue will be displayed, while the button on top of the selection list changes to
Hide Warnings ( 
).