InsertSurfaceLoftedRuled

The Ruled Lofted Surface command enables you to create ruled surfaces by starting the Lofted Surface command and automatically setting the proper parameters for the creation of a ruled surface.
Specifically, the surface Type under More Options will automatically be set to Ruled.

• For details on the command behavior, refer to the page on the Lofted Surface command.
   
• For a step-by-step example, see Creating a lofted surface starting from two boundaries (Ruled).
  Please note that the example refers to the Default mode of the Lofted Surface command: some of the initial steps listed therein are not required when you start the Ruled Lofted Surface directly.

Try to ...

• Clean a curve before creating a lofted surface