InsertDrawing ViewsMainTop
InsertDrawing ViewsMainFront                        
InsertDrawing ViewsMainLeft                          
InsertDrawing ViewsMainRight                        
InsertDrawing ViewsMainBack       
InsertDrawing ViewsMainBottom    
InsertDrawing ViewsMainRight Back   
InsertDrawing ViewsMainLeft Back   
InsertDrawing ViewsMainLeft Front  
InsertDrawing ViewsMainRight Front

The following commands enable you to insert a predefined two-dimensional view of a 3D model — say, for example, the following

 — into the current drawing. You can insert any of the following predefined views:
Top model viewed from the top (looking down along the Z-axis) perpendicular to the XY-plane of the World Reference System.
Front model viewed from the front (along the Y-axis) perpendicular to the XZ-plane of the World Reference System.
Left model viewed from the left (along the X-axis) perpendicular to the YZ-plane of the World Reference System.
Right model viewed from the right (along the X-axis) perpendicular to the YZ-plane of the World Reference System.
Rear model viewed from the back (along the Y-axis) perpendicular to the XZ-plane of the World Reference System.
Bottom model viewed from the bottom (looking up along the Z-axis) perpendicular to the XY-plane of the World Reference System.
Right Back model viewed as an isometric view from the right-back (along the line from coordinate 1,1,1 to the origin) relative to the World Reference System.
Left Back model viewed as an isometric view from the left-back (along the line from coordinate -1,1,1 to the origin) relative to the World Reference System.
Left Front model viewed as an isometric view from the left-front (along the line from coordinate -1,-1,1 to the origin) relative to the World Reference System.
Right Front model viewed as an isometric view from the right-front (along the line from coordinate 1,-1,1 to the origin) relative to the World Reference System.
Try to ...

Take a look at the video list  e-Learning on Layout