Select from the drop-down list the format of the current welding representation.

When you are inserting or editing a bead or a section, the program provides you the following possibilities:

	Single
	Double Select from the Current side drop-down list whether the current options apply to the weld above or below. Each side, therefore, has an independent set of options.
	Symmetric A single set of options is available and it applies to both sides.

When you are inserting or editing a welding symbol, the program provides you with the following possibilities:

	Single
	Double Select from the Current symbol drop-down list whether the current options apply to the weld above or below the reference line. Each side, therefore, has an independent set of options.
	Symmetric A single set of options is available and it applies to both sides.
	Sequence Indicates that a sequence of up to three independently defined welding steps apply (the figure shows a sequence of two steps). Select from the Current symbol drop-down list whether the current options apply to the first, second or third step of the sequence.